EXPANDED RF CROSS BAND REPEATER AM RECEIVE ON 118-136 MHz
1 Disconnect the battery and antenna.
2. Remove the three case screws and two battery plate screws.
3. Lift front panel from radio. Do not disconnect flex cables.
4. Remove chip resistor R128 and R129. Capacitor C124 may be glued down
over these Resistors. You may wish to unsolder the capacitor to avoid tearing the
flex board foil traces.
5. Reassemble the radio.
6. RESET the CPU.
AM sensitivity is typically less than 1uV for 10db S+N/N. CROSS BAND OPERATING PROCEDURES
Turn on /off the Repeater mode : Press and hold the [SUB UP] key and turn the power on.