EXPANDED RF/CROSS BAND REPEATER
1. Remove battery and antenna.
2. Remove screws open case.
3. Locate and cut diode D11. (440 Mod)
4. Locate and cut diode D 6.(440 Mod)
5. Install chip diode . (see drawing )(440 Mod)
6. Locate and cut diode D11
7. Locate and cut diode D8
8. Install chip diode, (see drawing)
9. Solder jump pads.
10. Locate and cut D 9 (Repeater mod)
11. Reassemble the radio.
12. Reset the microprocessor. (Press and hold [SUB VOL] & [MW] and turn power on)
CROSS BAND REPEATER PROCEDURES
TURN ON - Push and hold [SET], [MONI] & [CALL] & Mic down Button and turn power on.
TURN OFF - Push and hold [SET] then press [MHZ]