Please enable / Bitte aktiviere JavaScript!
Veuillez desactiver vos / Por favor desactiva el Javascript![ ? ]
MAGNUM Omega Force S45HP REPAIR TIP June 2010 | Radioaficion Ham Radio

MAGNUM Omega Force S45HP REPAIR TIP June 2010

Share

CB Radio MAGNUM Omega Force S45HP REPAIR TIP Update June 2010

Symptom:

While transmitting the radio "breaks lock" or the CPU malfunctions. Diagnoses,

1. Unsolder the shield of the coax that is connected to Output side of the RFX-75 where it connects at the radio.

2. Verify that there is continuity from the shield of the coax to the Chassis of the RFX-75. You may need to remove one of the screws holding the inspection plates on to the top or bottom of the RFX-75 and install one side of the ohm meter in the screw hole to get a good connection).

Cure:

3. If there is no continuity, remove the two screws that attach the RFX-75 to the back of the radio to gain access to the component side of the RFX-75. Locate the screw shown in the picture below, and replace it with a zinc or nickel plated 3MM screw. This will make the connection needed from the Coax Shield to Chassis Ground

CB Radio MAGNUM 257HP REPAIR TIP Update June 2010

Related Articles